Evaluation Request Personal Information Company Name (required) Your Name (required) Your Email (required) Evaluation Environment Information PC OS Information (required) *OS must be one of the followings. Windows 7 64-bitWindows 7 32-bitWindows 10 64-bit EtherCAT Slaves to be used *Type in the EtherCAT servo and I/O module vendors to be used if it is determined. Additional Information How did you find out about us? EmailInternet SearchWord of MouthOther For which application do you request our trial? Semiconductor manufacturing equipmentMounterFood manufacturing/processingPackaging machineAssembly machineTransfer machineInspection machineOther Currently using motion controller type PLCPCStand aloneOther Currently using motion controller Any questions or requests regarding trial version Trial Software Terms and Conditions Please read the following and agree to the terms and conditions below. All trial version software are valid for 90 days after installation. All software requires Windows 7 32-bit/64-bit, or Windows 10 64-bit OS. For other PC requirements, please check PC Requirements Page Trial version software of WMX2 is for 8-axis control. If more axes are needed, please inquire in the request field above. No hardware, PC, Servos, optional hardwares, NIC cards, etc, are included with the trial versions. A simulator software is included with the trial softwares. No servos are needed to run the simulator. For 64-bit trial software, Intel I210 Network Adapter is required. For 32-bit, see supported NIC list. WMX2 does not support all EtherCAT slaves. Please inquire to confirm if your EtherCAT slaves are supported. Soft Servo Systems, Inc. will not be held liable for any damages, injuries, or losses resulting from use of our trial version software. Please read through our Setup Guide and related manuals before installing and using our trial software. I accept the terms and conditions state above.